LIGHTSWITCH RE-DECORATION

(Repost from 2006)

After re-painting the livingroom and entryway, I decided it might be good to also change the light switches and electrical covers. After looking around at Home Depot, Menards and the like, I quickly realized that to replace all of the covers, I would have to spend more money than I had budgeted. So I decided to revamp the prominent light-switches using supplies I already had on hand. The only new supply I picked up was the scrapbook paper. My pictures didn’t turn out so hot, but you get the gist.

Supplies:
scrapbook paper in patter or color to match the room
glue (I used craft glue)
water
scissors
razor blade cutter (man I can’t think of the name right now – exacto knife, maybe?)

I took the scrapbook paper and made an outline of the lightswitch cover, cutting out the holes for the switches to fit through. I did not make holes for the screws; it wasn’t necessary.

Then I took the glue, mixed it with water (about a 1:3 ratio, glue:water). With a paintbrush and sometimes with my fingertips, I smeared glue on the back of the paper. Then, I placed the paper over the light-switch cover and smeared generous portions of the glue/water solution on the front. I let that dry a bit (10 minutes, maybe), then repeated with 2 more coats.

After that dried I put a clear protective spray over it that I had on hand (2 coats). I don’t know if it was necessary, but since I had it If figured I might as well use it for extra protection. I also did a little trimming of excess paper at some point during the process.

Voila.

They look pretty good, but I can see things I may have done different, like trimmed a little more or maybe even did a couple more coats of the glue water to make it even more durable. But oh well.

UPDATE: Three years later these have held up beautifully.